Electrocompaniet AW250R User Manual download pdf (Page 3)

Unpacking the amplifier:

Immediately upon receipt of the amplifier, inspect the carton for possible damage during

shipment. If the carton is visibly damaged, a claim must be filed with the carrier as soon as

possible.

Unpack the unit carefully, and please do remember to save all packaging materials for

future shipment. The carton and packaging have been designed to offer the safest possible

protection when transporting your amplifier.

The content of the carton is as follows:

1 pcs Electrocompaniet Ampliwire 250 DMB-R

1 pcs AC power cord

1 Owner's Manual

1 pcs Spare fuse, 10.0 AT slow-blow 5x20mm (120V AC)

5.0 AT slow-blow 5x20mm (240V AC)

The actual spare fuse is located inside the AC 3 pin receptacle.

Connecting the AW 250 DMB-R

Connecting to mains

Check that the mains voltage printed on the rear panel of the amplifier corresponds with

the line voltage in the territory were you intend to use your amplifier.

How to avoid damages

A good operating practice is to turn off all equipment before any connections or

disconnection’s are made. Do not under any circumstances connect or disconnect

equipment when power is turned on. If you insist on connecting or disconnecting while

power is turned on, you should be aware that the design of the RCA plug generates a

large transient when inserting the plug. This could damage both the speakers and the

amplifier.

The rear panel

The rear panel of the Ampliwire AW 250 DMB is equipped with two sets of RCA input

sockets, marked + and -, and one XLR female socket, for each channel.

Single-ended (RCA) input and operation

Upon arrival, the amplifier is set for single-ended use with a shorting plug in the negative

RCA input.This will short the negative (-) input of the amplifier to ground. With shorting

plugs in position, the amplifier is ready to be connected in a normal way with a single

ended preamplifier.

1 2 3 4 5 6 7 8

No comments

Electrocompaniet AW250R User Manual Page 3